Just did it. So easy, as long as it's only the switch and not broken wires. Two quick solders and you're good to go. I'm going to do my back up switch, just in case I need it down the road.

 

Are you talking about the driver's side switch module? I had soldered a couple of the connector points in the switch module (specifically under the window lock button) that were worn down. I also fixed a wire in the driver's door jamb and 2 in the passenger door jamb. Something I did rectified my no-passenger-window-action-from-ANY-switch problem for about a week, but then it crapped out again.


Wanted to make sure I wasn't missing something magical
Thanks

 

No magic. Just soldered the two connections by the lock button. Luckily, I don't have any broken wires.