i am whanting to hurculine my floor and is there a thred on this some where i cant find it

 

Shouldnt really need a thread...remove the seats,carpeting,center console. Put down huruliner...just make sure you dont get it in any holes you need for the bars the seats sit on. if you get a chiltons or haynes manual it will tell you how to completly remove your interiour

 

stryker did a good write up on this, i cant find it. maybe pm him

 

didnt do a write up but i did it. very easy and worth it since you get to fix all that rust before it gets worse..only downside is its louder in the cab. but i run no muffler and have my music on all the time so it doesnt bother me.

 

X2...Stryker did his floorboards with the roll-on stuff when he was fixin rust...check out his build thread...

 

it's quite simple really. As stated above, remove the carpet and everything you don't want herculined...or stuck on the floor. Sand down the surfaces that are getting painted, clean em up and then lay layer after layer down. Pretty much the same as painting rusty old parts.