What part do I need?
#1
Seasoned Member
Thread Starter
Join Date: Mar 2009
Location: I'm bad, I'm nationwide.
Posts: 397
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0
What part do I need?
Every once in a while my oil pressure gauge goes goofy, I pop the hood and look at the sending unit and the part of the harness that connects to the sending unit is zippy tied on. I wiggle it and the gauge quits acting up. I think maybe the little part of the harness is screwed up, It look like someone ripped it off then reconnected the wire to it the zip stripped it back on. Can I get this part of the harness?????
I can't get to a junk yard I live in the middle of nowhere. Anyone know where I can get this?
I can't get to a junk yard I live in the middle of nowhere. Anyone know where I can get this?
#2
Senior Member
Join Date: Apr 2009
Posts: 501
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Cherokee
Engine: 4.0L I-6
Cracked wires? What does the connector look like, corroded? Before you go cutting into your harness check it maybe put some of that electrolitic gel stuff in the connector. Just a thought.
#3
Seasoned Member
Thread Starter
Join Date: Mar 2009
Location: I'm bad, I'm nationwide.
Posts: 397
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0
Everything looks fine as far as I can tell, it just doesn't look stock. Like someone pulled it off on accident, re attached the wire but broke whatever was supposed to keep it on, Like the clip, or sleeve or something. It just plugs in and then its zip stripped down so it won't come out.
#4
Get us a pic of it so we can better see what has been done to it. It if is just a section of wiring harness that needs to be replaced, then I can check to local jy for it.
Thread
Thread Starter
Forum
Replies
Last Post
NM-XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
18
10-23-2018 04:21 PM
erupert66
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
7
09-15-2015 02:07 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)