Hi all,
So in my 2000 xj, I was doing some wiring work on my trailer and had accidentally crossed a couple wires inside the jeep(in the plug where I was testing the turn signals to make sure I get voltage back there).
Now my turn signals no longer work, my hazards still do. I replaced the relay under the headlight switch, the turn signal switch itself, and found a blown fuse in the power distribution panel under the hood; not even sure what fuse it was. I don't have a diagram for under the hood. The one one I saw did not clearly show which microfuse is what.

Regardless, TS still are not operating.

I also tested the plug that the relay goes into, I'm getting 12V for the hazards when they're on, but nothing for the TS.

Not sure where to go next, and I can't find anything to move forward, possibly my new relay is bad?

Any help would be greatly appreciated

-Dan

 

Thers two fuse panels .....http://www.lunghd.com/Tech_Articles/...tification.htm

 

I know, there was no fuse that was blown in this panel

 

Put a new fuse in for fun. (In the ts spot) sometimes the fuse doesn't "look blown" but it could be defective. You have a jeep; you have extra fuses.