well i got a 93 and my trunk is rusted out. so i was wondering if anybody around delaware area has a junker cherokee i could cut the trunk out of or if someone knows another solution

 

sheet metal.

if you havent done so already, pull all the carpet and check every bit of the floor.

depending on how bad it is you could cut all the rotted metal away and rivet/seal some good sheet metal in place. welding is more preferable, but you may not have access to it.

 

I can assure you, the "junker" will have the same situation.

I have a 94 Sport that has just gone under the knife (and welder)

You also want to check UNDER the bottom of the rear seat. In the outer-most corners. Use a screwdriver as there is a ton of factory sealer there and it can mask any rust.

 

me and my buddy just gonna cut out the bad parts and weld new sheet on top and treat it

 

SOunds like a plan, Buy some Rust converter for surface rust. THen you can rhino line the inside.


My Rig

 

stryker I like your trunk better than mine,, that is rolled on liner right,, I did mine sprayed... might do it again now that I see yours...