ok i have a 89 jeep xj with np231 and i would like to use a chevy transfer case but i have read some stuff on it and it looks like the transfer case will bolt up but they said that it would be 90 degees in different position
has any one seen info or used a set up like this
cause its hard as ***** to fint driverside drop axles and i would like to use some cheep chevy axles (everyone and there moms have them) lol!

 

look on car-part.com, you can narrow it down to your location. should be able to find everything you need, a bolt in is the easiest way to go, but if you are up to it you can put what you want in

 

no i wanna know if anyone has dont this?

 

if you want to run a chevy axle, why not use a dana 300 case?

but you'd have to re route your exhaust.