joshga171

When on any slope if I put my jeep in gear it doesn't want to pull I can put it in 4 low and it goes and once it changes to 2nd it goes fine. And after I get going the first time it will do just fine. I can stop it and go it does fine. And some times if I stop and take it out of gear then put it back in gear it will do the same. But as long as I keep it in drive it does fine 88 cherokee 4.0l automatic. Is my trans gone or is it something small!??!???

belvedere

Fluid level and condition? Type of fluid?

joshga171

Level was a little high but not much and I'm not sure of the type of fluid. It looks clean and I drained some out and it didn't have anything floating around in it

belvedere

Any chance someone put ATF+4 in it? Some folks have reported slipping because of it.

joshga171

I'm not sure. I've owned it for 3 years now but I sold it for about a month cause the original trans went out because a line busted on a trail and I didn't know it till it was to late. And my buddy caught me in a hard time so he bought it and put in this trans I bought it back from him like a month after he put it in. It was a used one from an grind that had it as his spare He may have put ATF+4. I don't know a lot about transmissions! What should be in it? can I just drain it and change it ?? Will that get it all out??