I have a track bar relocation bracket, how does it go on? it looks just like the part that is already on there, plus how is this going to solve the problem of my tire/wheel on the drivers side that sticks out about an inch? it looks like all the parts end up along the frame rail?? does anyone have insight on this

 

this help

 

I cant see it in there, does it go on the passenger side?

 

it goes on the axle pass side its the red thing on left side of pic .the yellow hole is where it bolts to where the factory bar did,the green hole is where the track bar is going to mount now, the red hole must be drill thru factory bracket and bolted together.

 

ok thank you very much. ill post a pic of how it goes

 

how does this solve the problem? the track bar seems to be connected to the frame rail?? the upper part of it....

 

it moves the body of the xj over towards the pass side helping with the centering of the axle under body

 

am i going to need some chains or come alongs to pull the bar to the bracket?

 

U could have someone turn the steering wheel while u try to line it up and slide the bolt in. That's the easiest way

 

no get the bracket all bolted up and unlock the steering by turning the key to run and turn the wheel the body will mve back and forth just figure out which way to go this must be done with the xj on the ground not on jack stand tires mounted two people really help with this

 

ok, im going to give it a shot, thanks for the help

 

yep

 

have you adjusted the toe yet,your going to need to loosen the adjuster at the drag link/ pitman arm with the wheels straight and turn the adjuster and the wheel will turn straight,make sure the steering is un locked

 

ok, so basically just doing a little alignment, man you sure are helpful, sorry for just posting that on your wall. Thank you very much man i appreciate it.

 

no prob any time i can help just ask .