throttle position sensor help
Thread Starter
Member
Joined: Jun 2014
Posts: 106
Likes: 1
From: Magnolia State
Year: 1999
Model: Cherokee
I'm new to the forum so hoping I'm in the right place for this question. Engine light came on. stopped by autozone to get info on code. says "PO122 and PO123, throttle position sensor". Anyone have any advice on this? Is this something serious? Seems to be running ok but may have a little hesitation when shifting gears (automatic). This is a '99 sport with 150K miles. I just realized this happened right after cleaning the engine. Thanks in advance.
Junior Member

Joined: Nov 2009
Posts: 70
Likes: 0
From: mcminnville TN.
Year: 1992
Model: Cherokee
Engine: 4.0
It's not serious unless it quits running.... That is attached to the side of the throttle body. You may be picking up some more than usual resistance. I would pull it off and clean it and where it goes into the throttle body. Also clean down inside the throttle body where the butterfly opens and closes. Use some good throttle body cleaner and watch how it comes out when you remove it. You will see when you remove the screws it will sort of tilt to one side. You will want to make sure you install it back the same way.
You probably killed the TPS when you washed the engine. I have done it twice now and finally made a cover for it. I also have louvers and rain killed one once also. Symptoms will range from delayed/no shifting to a searching idle. It takes about 5 minutes to change one out. I would recommend going OEM or buy two and keep one as a spare.
Thread
Thread Starter
Forum
Replies
Last Post
Psiegrist1
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
34
Mar 17, 2022 02:15 PM
JayneCobb
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
26
Aug 11, 2020 03:22 PM
mtoskippy
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
0
Sep 3, 2015 09:21 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



