so after i installed my rc 3" lift i get a little driveline vibe at 30mph then again at around 60mph its nothing really bad, I was just wondering if i installed a tcase drop is there any down sides to having one? i know you loose a little bit of clearance with them. but besides that anything else? or should i just forget the drop and just live with the vibe? also how difficult are they? is it just unbolting the old hardware, put the spacers in and then rebolt?

 

they are as easy as you described do you have the tc linkage brackets also

 

i havent gotten the tcase drop yet. i was just seeing if i should get one or if it would be alright to just live with the little vibe i get

 

It puts the front driveshaft in a bind so if you have 4hi full time it will give you a different vibe if you use it on the street and same if you have an automatic locker.

 

I dont have a locker, and its not in 4wd all the time i only use 4 when im wheel and i need it or in the snow during the winter

 

and it hangs lower, and can accelerate the destruction of your motor mounts.

 

X2 on the motor and tranny mounts.

 

im running 10.5 inches of lift had tc drop brackets installed for 6 years now no vibes no broken motor mounts maybe im just luck and mine is also my daily drive not a trailer queen 80 mph on the highway stop and go traffic every day

 

so ur saying the tcase drop would be fine?

 

I dropped my t/case. Driveshaft vibes are solved for the most part. But the linkage is binding..

 

you need the linkage drop kit also

 

the metal bracket on the right mine came with it

 

is that metal bracket the linkage drop? how hard is that to do?

 

its easy just very tight spot to work in it drops the linkage down where it mounts to the body i think its just 10mm wrench stuff its been a while since i did mine

 

ok so i could do it by myself, can i get by withouta tcase drop for a bit? would that be fine do to?