Nope > it might be the thicker gates belt I have.

 

I myself have had some issues with belt squeel. It ended up being that a little bit of coolant was seeping out from around the thermostat housing. It was lightly misting the belt and only losing a tiny amount of coolant. Thus even after the water in the coolant evaporated there was still a light coating of the coolant itself. And the rate of loss was so slow there was not particularly discernible loss of coolant.

 

Its not that, everything is shipshape its my belt, my mechanic thinks its the stiff belts.

 

Having the same problems, subscribed in case a good answer gets posted.

 

Are you using a stock belt? If its aftermarket that might be the problem. I put my old stock one on and no squeel, put my brand new unstretched gates belt and the squeel is back.

 

No mines stock. And only when the ac compressor is on

 

I had the same problem, my pulleys looked ok to me but new belts squeaked, I tried the pumice hand soap, the liquid worked better than the bar but only lasted a few days. I got mad and roughed up the pulleys with some 80 grit sand paper (I tried for a 60 degree cross hatch like you want on a cylinder wall) and the squeak died. I know this is not a permanent solution but it will do till i get around to doing that new water pump and radiator up grade I have been putting off. It couldn't hurt to try ther is nothing worse than the squeaky squeaky

 

Someone said tighten the tensioner a smiget till it goes away, try that. Ill jus let mine stretch then I'll turn my fan on again