Soldering injector harness?
Thread Starter
Member
Joined: May 2012
Posts: 109
Likes: 0
From: Pingree Grove, IL
Year: 2001
Model: Cherokee
Engine: 4.0L
Soldering injector harness?
So the PO of my jeep installed a crappy aftermarket remote start. For the tach source he spliced into the #4 injector control wire. It's cut about halfway thru, about half the strands still hanging on. My question is, how sensitive to resistance is the injector harness? If I solder this connection back up am I going to cause issues? I know solder does add resistance, although it may be very minimal.
::CF Moderator::
Joined: Aug 2011
Posts: 43,971
Likes: 1,577
From: Prescott, Az
Year: 1990
Model: Cherokee (XJ)
Engine: 4.0
So the PO of my jeep installed a crappy aftermarket remote start. For the tach source he spliced into the #4 injector control wire. It's cut about halfway thru, about half the strands still hanging on. My question is, how sensitive to resistance is the injector harness? If I solder this connection back up am I going to cause issues? I know solder does add resistance, although it may be very minimal.