shims with a SYE??
Thread Starter
Junior Member
Joined: Jul 2009
Posts: 64
Likes: 0
Year: 1996
Model: Cherokee
Engine: 4.0l high output
I know this is probobly a stupid question. I am doing an Iron Rock Hack & Tap SYE today and am removing the TC drop. Should I assume that the degree shims I put in will no longer be needed as well?? Thanks
Member
Joined: Aug 2009
Posts: 114
Likes: 0
From: Littleton, CO
Year: 1994
Model: Cherokee
Engine: 4.0
You have to shim the rear end so that the driveshaft is pointed directly at t-case output. actually it should about 2 degrees below that to compensate for axle wrap.
This site should help
http://www.myjeepxj.com/index.php?page=pinion-angle
This site should help
http://www.myjeepxj.com/index.php?page=pinion-angle
Thread
Thread Starter
Forum
Replies
Last Post
NM-XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
18
Oct 23, 2018 04:21 PM
mach3lude
Modified XJ Cherokee Tech
17
Sep 10, 2015 02:34 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



