and went off, I know I have a bad blower resistor as the old fan would only run on hi. ok so I checked the 30amp fuse and even replaced it although it didnt look bad, looked at other fuses but all looked well, I went to the plug that connects to the blower motor resistor and found that no power is coming to the plug, on the plug, I understand that the yellow with brown stripe wire should have power at all times but it does not have power now. This is a 95 Jeep cherokee country 4.0 auto trans. I have a replacement blower motor resistor ( the one that is under the passenger sided dash) but havent replaced it yet. did want to blow it of something wasnt right on the blower motor


thanks

M

 

if theres no power to the resistor switch on dash needs attention

 

thats what I was afraid of, should I pull the heat/ac controller out of dash

 

common prob easy fix

 

ok, pulled heat controller out of dash, plug looks a little mangled but not melted, double checked and plugged in and all works. did notice that the switch has 5 connections but only 4 wires coming to the switch. fan now works on lo, med 1 and med 2 but no high. looks like this is not factory switch as it has the markings on the top of the controller with yellow paint pen, which around here generally means a junkyard part. is this the right switch since I dont have but 4 wires coming up to the switch ??

thanks

maachuu

 

http://www.jeep4x4center.com/knowled...ex.htm#service go here look up your year and check out wiring diag think theres a wire missing for high should be 1 in 4 out i would think

 

check for power on all wire on the resistor maybe high burned up on it