rebuilt motor running hot
i just rebuilt the whole thing top to bottom and am getting some higher temps. it seems to be right past 210 but doesn't ever go under 210. its full of break-in oil, has new radiator, water pump, thermostat, new heater and rad hoses. is it normal for a new engine with break-in oil to run a little hot or is there something else i should try and replace. thanks you for the help. posted in modified too not sure where this belongs because its just the engine
in georgia so its hot here
in georgia so its hot here
probably around 20-30 miles total no highway yet and nothing over 3500rpm soo far, been wary about going far till it ran a little cooler might still get a new fan clutch but it makes sense it would run hotter with more friction from the oil and parts.
thanks for the help i wasn't really sure if it was normal and wanted to check with someone that knows more than i do. thank you
thanks for the help i wasn't really sure if it was normal and wanted to check with someone that knows more than i do. thank you
Last edited by xacto rocker; Aug 23, 2020 at 08:45 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Cherokeekid4x4
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
55
Jul 27, 2012 09:34 PM
rayneshwrs
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
14
Mar 11, 2011 09:22 AM
96xj33
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
17
Jul 7, 2010 12:44 PM
BayArea-Jeeper
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
16
Feb 5, 2009 01:52 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



