how are is it to replace a rear seal, and replace a right front wheel bearing? i have to fix the wheel bearing to stop my wobble, and replace my rear seal to stop it from leaking. and people know about this? any help would be appriciated

 

This a rear wheel seal?? If so you have to pull the axle shaft, the bearing is pressed on, I ended up taking it to the jeep dealer, 230.00.....

 

i have the equipment to do it. just the part of doing that. a little pain in the butt

 

wheel bearing is easy to replace. take off the wheel, caliper and rotor. 3 bolts hold the wheel bearing in place, think you'll need a 1/2 inch 12 point socket for them. Use a puller to take the wheel bearing off, you could also use an air hammer but that will bugger up the shield a bit. Good luck.