So im changing my axle ujoints now, along with other things. So far I have some questions. Im trying to get the axle hub nut off, but its spinning. Jeep is in park, ebraked, and 4low. How do I stop it from spinning?

 

I just finished that job, use an impact. if not try putting something in the yoke that will bind on the spindle.

 

Impact certainly makes it easier. But you should be able to free it with the tire on the ground and some pentrating oil.

http://www.myjeepxj.com/index.php?pa...nt-replacement

 

Are you replacing the hub bearing? If not you don't need to remove the hub nut. Just the 3 hub mounting bolts.

 

Just the ujoint, and im gonna rent the a tool at Checkers so I can do it with it still in the alse. So I can leave it on and just take off the hub mounting bolts?

 

You can do it that way but it is easier with the hub removed.

 

couldnt get the hub nut off with air tools, impact, or cheater bar and couldnt get ahold of somebody with a torch, so just pulled the whole driver shaft out by jumping up and down on the cheater bar lol. Passenger I can't even get the caliper off... any ideas?