problems but dont know the cause!
Thread Starter
Newbie
Joined: Jun 2012
Posts: 27
Likes: 0
From: vermont
Year: 1999
Model: Cherokee
Engine: 6cyl 4.0ltr
ok, i heard a snap and gind noise a couple times but haven't found a cause.
when i press the gas my jeep doesnt always go then its almost like the gears finally catch and then jerks forward and goes.
I have a vibration in my car when I hit 60mph
when in 4wd and turn, the steering wheel jerks back into place as well as the front axle.
have cleaned the crbarator, replaced the tps, replaced the other sensor next to the tps, had an alignment, had a balance, checked the axle shaft.
running out of ideas and money....
when i press the gas my jeep doesnt always go then its almost like the gears finally catch and then jerks forward and goes.
I have a vibration in my car when I hit 60mph
when in 4wd and turn, the steering wheel jerks back into place as well as the front axle.
have cleaned the crbarator, replaced the tps, replaced the other sensor next to the tps, had an alignment, had a balance, checked the axle shaft.
running out of ideas and money....
Junior Member
Joined: May 2012
Posts: 52
Likes: 0
From: Kingston, TN
Year: 2001
Model: Cherokee
Engine: 4.0
when i press the gas my jeep doesnt always go then its almost like the gears finally catch and then jerks forward and goes.
Start by checking the level and quality of your transmission fluid.
I have a vibration in my car when I hit 60mph
Check for loose/worn driveshaft u-joints. Also tires out of balance.
when in 4wd and turn, the steering wheel jerks back into place as well as the front axle.
While checking driveshaft u-joints, check the front ones first. When they bind they'll pull the steering wheel back.
Start by checking the level and quality of your transmission fluid.
I have a vibration in my car when I hit 60mph
Check for loose/worn driveshaft u-joints. Also tires out of balance.
when in 4wd and turn, the steering wheel jerks back into place as well as the front axle.
While checking driveshaft u-joints, check the front ones first. When they bind they'll pull the steering wheel back.
Thread Starter
Newbie
Joined: Jun 2012
Posts: 27
Likes: 0
From: vermont
Year: 1999
Model: Cherokee
Engine: 6cyl 4.0ltr
I have a vibration in my car when I hit 60mph
Check for loose/worn driveshaft u-joints. Also tires out of balance.
when in 4wd and turn, the steering wheel jerks back into place as well as the front axle.
While checking driveshaft u-joints, check the front ones first. When they bind they'll pull the steering wheel back.[/QUOTE]
we already checked the u joints on the drive shaft, already had a balance
Check for loose/worn driveshaft u-joints. Also tires out of balance.
when in 4wd and turn, the steering wheel jerks back into place as well as the front axle.
While checking driveshaft u-joints, check the front ones first. When they bind they'll pull the steering wheel back.[/QUOTE]
we already checked the u joints on the drive shaft, already had a balance
Thread
Thread Starter
Forum
Replies
Last Post
Psiegrist1
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
34
Mar 17, 2022 02:15 PM
2heapjeeps
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
13
Oct 4, 2015 10:52 PM
2heapjeeps
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
2
Sep 7, 2015 11:30 PM
Jeepy11
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
2
Sep 3, 2015 09:32 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



