popping noise when backing out
#1
Junior Member
Thread Starter
Join Date: Feb 2014
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
popping noise when backing out
My jeep is 2wd. When I back out of my driveway with the wheels turned all the way to the right I get a popping sound from the drivers side. With the wheel turned all the way it also feels like it is binding. The binding happens no matter what direction I am going when wheel is all the way to the right or left. I bought this jeep 3 weeks ago. I have replaced the motor mounts, one was broken. New shocks, they were leaking. New sway bar bushings and new endlink bushings. Midas said my lower ball joints were bad, so I replaced them myself over the weekend. The sound is still there. I also had a front end alignment done, and nothing was mentioned about tie rod being bent. I am clueless on what else could be the problem. IT does drive straight now and the steering feels solid. Any ideas?
#3
Junior Member
Thread Starter
Join Date: Feb 2014
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
popping noise when backing out
1999 jeep cherokee sport 2wd. Not lifted. 213k miles. When doing the endlink bushing I did notice the passenger side bracket for the endlinks had a slight bent towards the driver side. With the jeep on the ground I turned the wheels all the way both ways and I do not see anything rubbing against each other. When pushing down on the jeep I do not hear anything. Could it be the endlink on the passenger side rubbing against the spring causing the binding? The popping sound only comes from the front drivers side. Atleast that is where I hear the sound. Could be from somewhere else. My universal joints have no play on both sides for the drive shaft.
Last edited by nwagtmustang; 03-10-2014 at 01:27 PM. Reason: more info
#4
Junior Member
Thread Starter
Join Date: Feb 2014
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
The first pic is of passenger side endlink bracket bent. 2nd picture of driver side side endlink straight. Could that cause the popping noise or binding? Like i said the noise ia only from the drivers side. Any suggestions? I had free inspections at midas and firestone. They mentioned i needed new bushings and other things but never mentioned the bent bracket.
Thread
Thread Starter
Forum
Replies
Last Post
RunnerInPink
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
25
10-10-2017 10:34 AM
Doogluus88
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
7
09-01-2015 06:11 AM
NM-XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
7
08-25-2015 04:58 AM
mjcxking
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
11
08-23-2015 07:55 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)