Mine "clutch kit" didn't come with instructions on how to assemble the throwout bearing. I have 3 o'rings a little snap type washer and a tiny plastic tube.
So far I know that 2 o'rings go on the bleeder and feed tubes. But theres still another. Also have no idea where the snap washer or little plastic guy thing goes?

Any advice or insight to the problem?

 

The O rings go on the hydraulic lines where they slip into the connection on the bearing housing and the clips slip thru the hole in the connection and around the outside of the connection where the hydraulic line is inserted to hold the line in the bearing housing connection.

 

This is what I have left to use, 1 o'ring, the plastic tube like thing and the snap ring.


I already put 1 o'ring in each of the tubes where they belong. This is how it looks so far.


I'm assuming the snap ring goes over the circled area to keep the throwout bearing in place?


But then where do the little plastic tube goes, and theres an extra o'ring as well. This is my first hydrolic throwout bearing experience and it sucks!

 

Come on guys, need help! I'm right in the middle of this install and running out of day light!

 

most likely the o rings an extra the pin is allready in the red circle the other pc/clip goes on the pin in the red circle to hold the throw out bearing to the tranny

 

So if I'm understanding this right the o'rings an extra. And the little black plastic thing isn't needed?
And the clip goes over the guide to hold the TOB in place.

I figured the o'ring was extra but that plastic thing is kinda got my clueless..

 

every time ive done mine i got a oring new clip and pin never a plastic tube as long as the clips onon and theres a a oring on the hydralic tube put it back together what ever you do do not cut the little strap on the side of the bearing it will break when you bleed the system

 

Ya the kit cam with 2 u-shapped pins that hold the feed & bleeder tubes. I have a o'ring & pin in each.
I'll add the other o'ring in the feed line where it connects to the other line. I think that plastic peice may slip over that guide. The plastic thing has a slit in it like it would slip over something, and side the TOB has a little play I think it goes there. I think I got it figured out.

Thanks so much guys!