p1388
Its a 97 country. That's the only code its throwing. I also have no spark and no rpm on the scan tool. I even HotWired the ASD to send voltage to the coil. Still no spark. I have even checked all grounds in the engine compartment and all check good. 0 ohms. I did an ohm check of the crank sensor and it tests good. On the coil driver circuit I have 110k ohms. I measured it by unplugging coil and putting one lead into driver side and one on the battery. I wanna replace the crank sensor but it tests good. I'm worried now that the ignition module of the ecu is shot.

 

Swap the ASD relay with the AC relay. See if issue and code go away. BYpassing the relay is going to CAUSE the code.

 

Relay is good. My ground circuit through the PCM has 110k ohms. I ohmed the PCM bare from pin 7 c1 to pin 32 c3. Seems too high and is a faulty pcm

 

1388 cleared. Am getting code p0340 now. Camshaft failure. Also view no Rpm on scan tool