Is there a way to program a keyless entry remote on a 2000 at home I know most cars you can be turning key on and off while lights are on or something long that line.

 

No you have to take it in to a dealer or a shop that has a starscan tool! sucks i know

 

not true

if it is a 2000 xj here is what you do..

1 Press the LOCK button for 4 to 10 sec on the remote and the door
2. While the LOCK button is pressed (after 4 sec) press the PANIC button, release both buttons.

If it works, then when you hit the Lock button the doors will lock


I believe it is page 25 or 26 in the owner manuel..

 

http://www.jeep4x4center.com/knowled...rogramming.htm

 

i got this from your link

 

i fixed it go again

 

cool now i know how to program a chip key...

 

my bad didnt work on my WJ '99...

 

http://www.jeepforum.com/forum/f13/w...-entry-923437/

 

<<<< open mouth insert foot! lol

huh where was that when I was searching!!! thanks I had a star scan at the time tho

 

Were is the eye for the remote on a2000????? Located

 

I'm not sure now that my jeep had keyless entry on it how do I tell?

 

keyless remote: got one of these? I belive all 2000 cherokees with power locks can use the remote, though my owner's manual says it's optional. Seems new remotes must be programed by the dealer....unless freegdr's link does the trick.



Keyless Entry Remote Fob Clicker for 2000 Jeep Cherokee - Memory #1 (Must be programmed by Jeep dealer)

 

Just went through this on my 00, my se came with just about everything but RKE, and I wanted factory stuff so i went to picknpull, borrowed a harness that runs from the pass kick panel up to the roof and the module , installed in mine and had to have a buddy with a drb tool program it for me.

 

did this work for you?