NP231 Output Shaft Dust Cover
#1
Senior Member
Thread Starter
NP231 Output Shaft Dust Cover
How do I remove the pressed-on metal dust cover on the rear output shaft of this NP231 TC?
I tried heating it up, but there is really no pry point.
Thanks.
I tried heating it up, but there is really no pry point.
Thanks.
#3
Senior Member
Thread Starter
Yes. I'm splitting the cases to inspect before install. There were some flakes of metal in the fluid so I'm thinking the synchro ring might need replacing.
#4
Senior Member
Thread Starter
I will eventually install a SYE, so I'm curious how you got that small cover off? The one that gets replaced when installing the SYE. I think I'm going to need a puller. I got the snap ring off but the cover only lifted about a quarter inch and wouldn't budge any further.