I have a 98 I have replaced plugs wires cap rotor coil checked fuel press compression I have also changed crank position sensor. I have a single spark come from my coil when I hook a plug to it I also have 5 volts at the plug for the distributor when I crank it over I have ohm tested all fuses and I'm lost don't know what to check next oh yea also pulled the horn relay in case of a bad clocking ring

 

did you have spark before changing all the components?

 

no i drove it home shut it off the next morning would not sTART

 

dumb question, but did you check your fuses / etc? If you shut it off and now it won't get spark, then something happened between when you turned off the key and when you went to restart. Start simple with the fuses / relays and go from there.

 

Yes I ohm tested all fuses

 

Where did you get your new cps from? If it was anything other then an oem one that may still be your problem. After market are known to be bad right out of the box.

 

Ok I do not have 5 volt power supply to my computer or PCM where does it come from and can any one get me a wire schematic so I can figure out where the power supply comes from for the pcm