Hey there just bought my 98 Cherokee Classic Automatic, Inline 6 engine. Was running a little rough so I replaced PLUGS, WIRES, Dis. CAP and, ROTOR. Started and run BEFORE. After replacing all these items now the engine won't start. Just cranking no start up?!

 

firing order wrong

 

That is what I'am thinking! But I have checked them 10 times now..

 

is there spark coming out of the coil? do you have fuel pressure? are your plugs gapped correctly?

 

Looking at "cause and effect" (which is in play here as it ran before you installed these parts), the problem is almost assuredly related to the work performed.

Go back and verify everything. Be sure the coil wire is seated securely into the coil.

 

did you do one wire at a time or use the haynes manual

 

Hayes manual is junk! Found the correct dis. order from some body on here. Runs just fine now.

 

yep haynes is right but the dist screws are drawn in the wrong spot