A little help needed
#1
Newbie
Thread Starter
Join Date: Mar 2012
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
A little help needed
My daughters 2000 grd cherokee has intermittent shift indicator lights. I pulled the console and the flex circuit was lit and working. Any suggestions.I'm retired ASE and IATN, so if you point me in the right direction, I should be able to fix it.
#3
Newbie
Thread Starter
Join Date: Mar 2012
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
I did some research and there are no bulbs in this setup.
Shift console lighting
The shift console uses a membrane for its lighting, there are no bulbs that can be replaced. The shift handles are a pain to remove, but you can leave them on to get to the lighting strip which is located under the shift plate cover. Check the wiring for the light strip, I believe it is an orange wire. If the light strip is defective it is not available separately, the shifter parts only come as a complete assembly.
Accessing the shift gate blinds
The shift gate blinds can be assessed once the console is removed for cleaning and repair. The top shift plate cover is held on with four plastic clips, two on each side. The cover can be lifted up a couple of inches, allowing enough room to access the gate blinds. In most cases mis-aligned blinds can be readjusted into place if they are not damaged. None of the parts of the shift console are available separately, the entire unit is serviced as one piece.
Shift console lighting
The shift console uses a membrane for its lighting, there are no bulbs that can be replaced. The shift handles are a pain to remove, but you can leave them on to get to the lighting strip which is located under the shift plate cover. Check the wiring for the light strip, I believe it is an orange wire. If the light strip is defective it is not available separately, the shifter parts only come as a complete assembly.
Accessing the shift gate blinds
The shift gate blinds can be assessed once the console is removed for cleaning and repair. The top shift plate cover is held on with four plastic clips, two on each side. The cover can be lifted up a couple of inches, allowing enough room to access the gate blinds. In most cases mis-aligned blinds can be readjusted into place if they are not damaged. None of the parts of the shift console are available separately, the entire unit is serviced as one piece.
Thread
Thread Starter
Forum
Replies
Last Post
2000CHERO
Modified XJ Cherokee Tech
20
10-12-2015 11:03 PM
william50
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
08-31-2015 02:19 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)