well, when i installed my new JCR tail lights, i had wired everything up correctly and when i had tested the directionals, they are blinking quicker then normal. like if you were to have a OEM tail light out, my question is, how to make them flash like normal. what do i have to change?

 

friend of mine did the same thing , I thinks its normal

 

That is normal for when you have a flasher with lamp out indicator.... They flash fast when it doesnt pick up enough of a load on it...
Since LEDs dont draw a 10th of the amps a incandescent bulb does it thinks it has a lamp out...
You can either find a flasher with out lamp out indicator...... or install these inline and then the lights will blink slow like normal...http://www.virtualvillage.com/2x-led..._medium=shcomp

 

how can i get the turn signal to go slower, like normal. is there something i could do to the relay.

 

Check out this link they should have exactly what you need and also have a crossreference chart to all the bulbs in your vehicle.
http://www.superbrightleds.com/cgi-b...rake-turn.html

 

Post up some pics of the lights installed.

 

here are some pics of the JCR tail light armor installed

 

were did you find them JCR tail light armor plates at

 

that is not normal. you need to go get a load equalizor from autozone. they sell them by the bulbs.

they are cheap too

 

http://www.jcroffroad.com/index.html

 

what do you do for reverse lights to keep it legal?

 

autozone... they have a thing u wire in inline with the taillights to fix this... look in the section where they sell the LED light bulbs...

 

I will put two holes in the existing bumper with the hole saw i have and put two square reverse lights in.

 

they do have white LED lights in eBay... there bout $40 for the oval ones... ill be running them...

 

ya, white l.e.d seem really good for reverse lights, ill look around for them and pick sum up.