Hydrolocked. Now won't start
Thread Starter
Newbie
Joined: Apr 2017
Posts: 5
Likes: 0
From: New Jersey
Year: 1995
Model: Cherokee
Engine: 6 cylinder 4.0
Hydrolocked. Now won't start
went mudding and I hydrolocked pretty badly. Pulled spark plugs and did normal when fixing hydrolocked motor. Still would not start. There's no spark now. Replaced cap and rotor. Still nothing. Replaced crank sensor. Nothing. What else could be the issue? I have a 95 4.0
Last edited by Tommyapples; Apr 13, 2017 at 03:55 PM.
CF Veteran
Joined: Nov 2010
Posts: 5,841
Likes: 117
From: In the middle of Minnesota!
Year: 1999
Model: Cherokee
Engine: 4.0
Test/swap ASD relay, test coil for starters. Did the computer get wet?
-----------------------------------------------------------------------------------
Spark: 12 volts from ignition switch to the ASD relay; when the key is first turned on the PCM provides a ground to the ASD relay to energize it, then the ASD relay passes 12 volts to the coil primary side. If no crank sensor signal is generated after a couple of seconds the PCM cuts the ground to the ASD relay (and fuel pump relay too) and that cuts power to the coil (and fuel pump). Key to START and once again the PCM energizes the ASD relay. Now, a critical element is the crank sensor--no signal from the crank sensor and the PCM won't trigger the coil to provide spark.
-----------------------------------------------------------------------------------
Spark: 12 volts from ignition switch to the ASD relay; when the key is first turned on the PCM provides a ground to the ASD relay to energize it, then the ASD relay passes 12 volts to the coil primary side. If no crank sensor signal is generated after a couple of seconds the PCM cuts the ground to the ASD relay (and fuel pump relay too) and that cuts power to the coil (and fuel pump). Key to START and once again the PCM energizes the ASD relay. Now, a critical element is the crank sensor--no signal from the crank sensor and the PCM won't trigger the coil to provide spark.
Thread Starter
Newbie
Joined: Apr 2017
Posts: 5
Likes: 0
From: New Jersey
Year: 1995
Model: Cherokee
Engine: 6 cylinder 4.0
Test/swap ASD relay, test coil for starters. Did the computer get wet?
-----------------------------------------------------------------------------------
Spark: 12 volts from ignition switch to the ASD relay; when the key is first turned on the PCM provides a ground to the ASD relay to energize it, then the ASD relay passes 12 volts to the coil primary side. If no crank sensor signal is generated after a couple of seconds the PCM cuts the ground to the ASD relay (and fuel pump relay too) and that cuts power to the coil (and fuel pump). Key to START and once again the PCM energizes the ASD relay. Now, a critical element is the crank sensor--no signal from the crank sensor and the PCM won't trigger the coil to provide spark.
-----------------------------------------------------------------------------------
Spark: 12 volts from ignition switch to the ASD relay; when the key is first turned on the PCM provides a ground to the ASD relay to energize it, then the ASD relay passes 12 volts to the coil primary side. If no crank sensor signal is generated after a couple of seconds the PCM cuts the ground to the ASD relay (and fuel pump relay too) and that cuts power to the coil (and fuel pump). Key to START and once again the PCM energizes the ASD relay. Now, a critical element is the crank sensor--no signal from the crank sensor and the PCM won't trigger the coil to provide spark.
CF Veteran
Joined: Nov 2010
Posts: 5,841
Likes: 117
From: In the middle of Minnesota!
Year: 1999
Model: Cherokee
Engine: 4.0
