I did some searching..to no avail

so , i swapped out my disco HP30 into my 88, with a non disco HP30, non abs knuckles with the larger abs (760) shafts? when i got the axle it was in pieces, and i had my disco axle as well.

I had just put all new front brakes on the disco..so would like to keep that part..and i like the older 2 piece knuckle.(already modded for otk)

so here is my question..could i use the older knuckles and brakes with the new housing and 760 shafts? was just really concerned with the ball joints and the taper? are they the same?and is the HP30 non abs a 91-96?(for future parts reference)

 

This should be easy for you guys

 

Short answer yes as long as you use all the parts from the disco ( hubs rotor caliper )

 

Works for me.just need to get a drivers side shaft for 760 joints then.thanks.