Homemade rear bumper and tire carrier fab job pictures
02-28-2009, 03:41 AM
#31
Junior Member
Thread Starter
Join Date: Oct 2008
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
The swivel consisted of a 1 1/4" sch.40 pipe on top of a 1" sch. 40 pipe and then a 3/4" bushing inside of that. Then I used a bolt for the actual pin.
05-23-2009, 08:25 AM
#32
Senior Member
Join Date: Mar 2009
Posts: 658
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1993
Model: Cherokee
Engine: 4.0 H/O I6
i would like to build one of these, but i like being able to see out of my rearview. im going to come up with one that doesnt move off the hatch, just reenforce it so when you lift the hatch the carrier goes up with it. basically just attatch it to the hatch itself and move the license plate
05-23-2009, 09:30 AM
#33
"CF Moderator"
Join Date: Sep 2008
Location: N.J. Shore Area
Posts: 3,045
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1994
Model: Cherokee
Engine: l6 HO
i would like to build one of these, but i like being able to see out of my rearview. im going to come up with one that doesnt move off the hatch, just reenforce it so when you lift the hatch the carrier goes up with it. basically just attatch it to the hatch itself and move the license plate
05-23-2009, 07:15 PM
#34
Junior Member
Join Date: May 2009
Posts: 98
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1995
Model: Cherokee
Engine: 4.0L HO
Amazing work man! I was wonder what you used for the angle iron and flat stock metal peices. I would like to build my own just would like to get some demenions before i start. I got 2x3 3x3 angle iron but i don't think its big enough as far as the flat stock goes i got 1" - 4".
Thread
Thread Starter
Forum
Replies
Last Post
PopsOldXJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
08-25-2015 06:38 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)