helpp!! Driveshaft problems..I hink
#1
Member
Thread Starter
Join Date: Mar 2010
Location: scranton, pa
Posts: 107
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0 HO
helpp!! Driveshaft problems..I hink
wen i hit the accelerator it sounds lile the driveshaft is buckling, but it only does it until i start movin like 5mph then id dosent do it again. only at stop signs and red lights..someone help its starting to scare me and im new to this site so hi everybody!!!
#2
CF Veteran
sounds like it's just your 4wd lever bushings are worn out. the linkage will tap against the side of the floor/tranny tunnel at take-off.
if not, then it's likely a bad u-joint on your rear driveshaft.
if not, then it's likely a bad u-joint on your rear driveshaft.
#4
Member
Thread Starter
Join Date: Mar 2010
Location: scranton, pa
Posts: 107
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0 HO
it dosent only happen when its in 4wd, but its like a clunk clunk, kinda as if the knuckles on the driveshaft were hitting the floor haha but they arent
#5
Junior Member
Join Date: Jan 2010
Location: Gulf Shores, Al
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: 4.0
#6
Senior Member
Join Date: Apr 2009
Location: Phillipsburg, NJ
Posts: 718
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.ol renix
I just had this same problem. Iy would happen very faintly in 2wd but in 4wd it would be very loud. I swapped Drive shafts and it went away. Since my u joints were almost new I assume it's either the centering ball in the cardan joint or the slip joint. Im leaning toward the centering ball because it had quite a bit of play.
Trending Topics
#10
Senior Member
Join Date: Apr 2009
Location: Phillipsburg, NJ
Posts: 718
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.ol renix
would a sye kit fix this problem?
Last edited by Skreed; 03-11-2010 at 02:36 PM.
#12
Senior Member
Join Date: Apr 2009
Location: Phillipsburg, NJ
Posts: 718
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.ol renix
any cheap ones out there that are good?
I did give you some input and now I am going to kindly tell you to search SYE there is more info on SYE's than I ,one man, could possibly tell you.
#13
Member
Thread Starter
Join Date: Mar 2010
Location: scranton, pa
Posts: 107
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0 HO
well thanks, but im going to go with a true SYE kit i would rather not get a hack and tap b/c i dont want to break down in the woods haha