Has anyone done the zj disc to d44 conversion??
Thread Starter
CF Veteran
Joined: May 2009
Posts: 1,537
Likes: 1
From: AL
Year: 2001
Model: Cherokee
Engine: 4.0l
Has anyone done the zj disc to d44 conversion??
CF Veteran
Joined: Jan 2009
Posts: 2,740
Likes: 0
Year: 87
Model: Cherokee
Engine: 4.0
WHat do you need to know... I did this swap on my 87.
You will to open up the center hole on the brake backing plate about 3/16's, you will also need to redrill the backing plate for the xj d44 pattern. I used TJ rubicon axle retainers.. I also had them drilled. I dropped al these parts off at a machine shop, and 100 bucks later it was good.
Alloy USA used to sell (stil might) alloy shafts for the d44 with all the parts you need to do the swap(as far as the ahafts go) plus dual bolt pattern alloys for 300.
You will to open up the center hole on the brake backing plate about 3/16's, you will also need to redrill the backing plate for the xj d44 pattern. I used TJ rubicon axle retainers.. I also had them drilled. I dropped al these parts off at a machine shop, and 100 bucks later it was good.
Alloy USA used to sell (stil might) alloy shafts for the d44 with all the parts you need to do the swap(as far as the ahafts go) plus dual bolt pattern alloys for 300.
Thread
Thread Starter
Forum
Replies
Last Post
FS[SouthCent]: 4.56 gear set and master install kits D30 and D44
dcollins3208
Axles/Tires/Wheels
12
Dec 11, 2015 11:49 AM
FS[GreatLakes]: Aw4 Transmission 67xxx miles
JeepStephie99
Engines/Tranny/T-Case
14
Nov 19, 2015 11:49 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)