Sorry if this is a stupid question, but I was looking under my rig for things to grease with my grease gun and they only thing I saw with a grease fitting is the front shaft but not the rear one, doesn't it not have one? What else should I be greasing?

 

Seems like 6-8 grease fittings up front, don't recall exactly, none on the rear drive shaft unless u replace the non-greasable u-joints with greaseable.

 

Were are they all located?

 

Backside of the wheels (ball joints) and steering linkage.

 

If you are 4x4 lower ball joints don't have grease fittings. No clearance for axle u joints. You will need a grease needle.

 

IIRC, no lower ball joint fitting on 4X2 either, just uppers and steering linkage.

 

How often should a grease these? To be honest iv nvr greased them, if I do so would I notice anything like smoother performance?

 

Probably no performance improvement but thw will last a lot longer and they are NOT fun to replace.

 

Every oil change......bad things happen when proper bumper to bumper maintenance is neglected.