Gonna attempt to replace hub/bearing assembly and pull axle shaft.
Thread Starter
Junior Member
Joined: Sep 2010
Posts: 99
Likes: 0
From: So-Cal
Year: 2001
Model: Cherokee
Engine: 244 c.i.
Gonna attempt to replace hub/bearing assembly and pull axle shaft.
Do I need a press to remove or install the hub assemblies??
I read that the hub nut is 175 ft-lbs. True??
Than I also wanna pull the axle shafts to inspect 'em and help to build my knowledge playing with Jeeps as well. Hard to do??
All this kinda make me
but am exited to do.
Any advise and/or special tools??
Thanks.
I read that the hub nut is 175 ft-lbs. True??
Than I also wanna pull the axle shafts to inspect 'em and help to build my knowledge playing with Jeeps as well. Hard to do??
All this kinda make me
but am exited to do.Any advise and/or special tools??
Thanks.
Senior Member
Joined: May 2010
Posts: 882
Likes: 1
From: MI 48642
Year: 1996
Model: Cherokee
Engine: 4.0
the hub assembly comes as one unit so no pressing needed, and 175 is correct. the shafts pull right out after the hub is off, however if you have rust or anything nasty in your tubes you may want to reconsider doing that. Sucks trying to get the shaft back into the tube without contacting the sides on the way.
Thread
Thread Starter
Forum
Replies
Last Post
RunnerInPink
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
25
Oct 10, 2017 10:34 AM
HuntinXJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
Aug 23, 2015 04:09 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)