Gear pattern critique
#1
CF Veteran
Thread Starter
Gear pattern critique
Hi Guys,
I've been re-gearing a junkyard HP Dana 30 for my 2001 XJ, The axle had 3.07 gears in and i put 4.10 in it with a ARB locker. The 3.07 pinion did not have any depth shims, so I have a bit of extra trial and error getting them set up. I am fairly happy with my current results, but I would like a little feedback on my pattern.
Pinion depth is .048"
Backlash is .0065"
Pinion pre-load is about 20in lbs
Carrier pre-load will be set by adding .004" to each side of the carrier upon final assembly.
thanks in advance
-Rob
I've been re-gearing a junkyard HP Dana 30 for my 2001 XJ, The axle had 3.07 gears in and i put 4.10 in it with a ARB locker. The 3.07 pinion did not have any depth shims, so I have a bit of extra trial and error getting them set up. I am fairly happy with my current results, but I would like a little feedback on my pattern.
Pinion depth is .048"
Backlash is .0065"
Pinion pre-load is about 20in lbs
Carrier pre-load will be set by adding .004" to each side of the carrier upon final assembly.
thanks in advance
-Rob
Last edited by robsjeep; 12-17-2018 at 09:58 AM.
Thread
Thread Starter
Forum
Replies
Last Post
huntingman2706217
Wanted
0
02-10-2010 10:21 AM
redhanded
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
9
11-25-2009 11:10 AM
DBoomgaard
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
5
06-23-2009 10:43 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)