I've searched, but haven't found my exact problem.

the bolt seized in the bushing, but i thought i backed it out far enough that it is clearing the threads. i cut the bolt off on the inside of the bracket on the other side expecting it to just fall, but it is still hung up some where in the frame. i tried pulling and tugging and getting aggressive with it to no avail. at this point im thinking maybe of drilling a 1/2 in hole behind the bolt and just giving it a few taps to make it all the way through. any suggestions on this? thanks guys, i dont know where to go from here.

 

Sawzall between the bushing and the frame rail.

 

if i do this, id have to knock out what remained in the frame and retap it, correct?

 

i have this problem on machines at work a lot cut it with the sawzall then take i bolt and weld it to the cut one on like a 45 the heat will break it losse then it should back off i got luck with my jeep with the bolts

 

i have no access to a welder, but maybe i could drill in a screw or something?

i dont know. this stupid bolt has been holding up my lift a long time now.