Front Driveshaft Rebuild Gone Wrong...Help? (U-Joint Alignment)
#1
Seasoned Member
Thread Starter
Join Date: Sep 2011
Location: Cumming/Dahlonega, Georgia
Posts: 311
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Cherokee
Engine: 4.0L
Front Driveshaft Rebuild Gone Wrong...Help? (U-Joint Alignment)
Hey all,
I am in the middle of rebuilding my front driveshaft, or so I hope, and I am absolutely stumped. I worked on it for 7 hours today...yes, that's right...7 hours on 3 U-joints. Here's the problem:
The U-joint on the axle end went in no problem, probably because it's not part of the double cardan end. I also got the 2nd U-joint in with no problems, the one in the "middle" that has all 4 snap-rings, etc...
My problem is, I simply cannot get the last U-joint installed. I even tried installing the last one first, then the centering yoke, followed by the "middle" joint, but with absolutely no luck.
I can get the two ends into the centering yoke just fine, and the ball lines up with the spring, dust shield etc...just like it should. However, the two ends that have snap-rings...I can't get them even close.
I can get both ends into their respective holes, but I can't get them lined up enough to even start one of the caps.
Any insight/tips?
I have looked over Stu's writeup, as well as the myjeepxj.com writeup, and it feels like I'm doing everything as I should be.
I am in the middle of rebuilding my front driveshaft, or so I hope, and I am absolutely stumped. I worked on it for 7 hours today...yes, that's right...7 hours on 3 U-joints. Here's the problem:
The U-joint on the axle end went in no problem, probably because it's not part of the double cardan end. I also got the 2nd U-joint in with no problems, the one in the "middle" that has all 4 snap-rings, etc...
My problem is, I simply cannot get the last U-joint installed. I even tried installing the last one first, then the centering yoke, followed by the "middle" joint, but with absolutely no luck.
I can get the two ends into the centering yoke just fine, and the ball lines up with the spring, dust shield etc...just like it should. However, the two ends that have snap-rings...I can't get them even close.
I can get both ends into their respective holes, but I can't get them lined up enough to even start one of the caps.
Any insight/tips?
I have looked over Stu's writeup, as well as the myjeepxj.com writeup, and it feels like I'm doing everything as I should be.
#2
Seasoned Member
Thread Starter
Join Date: Sep 2011
Location: Cumming/Dahlonega, Georgia
Posts: 311
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Cherokee
Engine: 4.0L
I gave it another shot this morning with no luck....anybody?
It's my front DS, LP30, NP242, replacing joints with Spicer 1310's.
It's my front DS, LP30, NP242, replacing joints with Spicer 1310's.
Thread
Thread Starter
Forum
Replies
Last Post
RickJames Bish
Modified XJ Cherokee Tech
5
09-02-2015 03:22 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)