Exhaust Manifold: Same for RHD and LHD models?
#1
CF Veteran
Thread Starter
Exhaust Manifold: Same for RHD and LHD models?
back again
my exhaust manifold is going, it ticks/puffs where it has rusted at the join between the two three pipe sections. Exhaust putty has held it for about a year but it's going to fail inspection this time.
My question is: can I fit the cheapo stainless tubular manifolds from ebay on a Right Hand Drive Jeep? I can't find any mention of there being differences between RHD and LHD Cherokees but there are sometimes different exhaust pipes in other vehicles depending on the steering column etc.
The only exhaust headers available in the UK are second hand from junk yards and since this is a weak part I'd be wasting my time fitting one as old as mine so I'll be looking to get a replacement from the USA.
Any advice welcome!
thanks,
Morat
my exhaust manifold is going, it ticks/puffs where it has rusted at the join between the two three pipe sections. Exhaust putty has held it for about a year but it's going to fail inspection this time.
My question is: can I fit the cheapo stainless tubular manifolds from ebay on a Right Hand Drive Jeep? I can't find any mention of there being differences between RHD and LHD Cherokees but there are sometimes different exhaust pipes in other vehicles depending on the steering column etc.
The only exhaust headers available in the UK are second hand from junk yards and since this is a weak part I'd be wasting my time fitting one as old as mine so I'll be looking to get a replacement from the USA.
Any advice welcome!
thanks,
Morat
Thread
Thread Starter
Forum
Replies
Last Post
cpnwrench
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
13
02-15-2024 08:09 AM
libengan
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
14
11-06-2015 09:16 AM
Snajo
Other Vehicles. Other Jeep models & cars and trucks of other makes
0
09-26-2015 11:54 PM
little smathers
Modified XJ Cherokee Tech
0
09-20-2015 03:32 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)