I'm in the middle of swapping a 4.0 out of a 98 into my 92. My question is I swapped over my A/C condenser mount to keep the idler pulley, now I'm at the point where I'm trying to to put the power steering pump bracket on and the one out of my 92 will not fit the intake manifold. What is the solution here? Delete the idler pulley off the A/C condenser mount and use the power steering pump and bracket from the 98? If so what belt routing do I follow? 98 I would assume?

Thanks in advance, this is my first time swapping a 4.0 and this is the only issue I've ran into. If I have to I can reuse the intake manifold off my 92.

On a side note I plan on swapping in a 99+ intake in the near future, I'm going to make the assumption that the power steering pump mount is the same as the 98?