Is there anyway to simply completly turn off/disconnect the ABS system? Mine will randomly act up and this winter it will probably kill me if it keeps acting up. I also hate ABS, so instead of finding the problem (I'm guessing a bad sensor in one of the wheels) I would prefer to just disable it and have normal brakes. Anyone ever do this? Can it be done?

Thanks,
Jon

 

pull the fuse. Your warning light may stay on but your ABS will be disabled

 

Cut the wires and pull the fuse.

 

Yes theres two fuses in the fuse box under the hood theres a fuse and a relay pull them both and it wont kick on any more and no dash light i did and its been a year since and still no light

 

I wouldn't cut the wires. If you want to sell it later the buyer my want ABS for some unknown reason. You can just un plug the connection . The rear one is under the back seat and the front is under the hood. Just follow the wires back up from the axles till you find it. Then get a ziplock bag and put over the connections to keep them clean. This will give you non ABS brakes and the ABS light on the dash will be on. And the ability to connect it back up.

 

Sweet! That was very easy. I just pulled the fuse, still braking just fine.

Thanks, Guys!

 

What fuse did you pull?

 

i'm gonna go out on a limb here and say the ABS fuse

its in the under hood fuse box

 

Man dukie564 u a all over this fourm u seam to know your s...

 

That I do

 

Have u cut you fenders?

 

off topic - check my build - done the very front so far

 

Duke you where right thanks, they are the big ones on the right colume next to the the little ones. A 20 and a 40 amp. Sky line told me, I could not find a listing for the fuses any where. Dang 2000 models.

 

Does this same principle apply If I swap the rear axle, just disconnect wires/fuses and done? thanks

 

yessir