dana 35 and chrystler 8.25
Thread Starter
Senior Member
Joined: Mar 2011
Posts: 643
Likes: 0
From: San Antonio, TX
Year: 2001
Model: Cherokee
Engine: 4.0L
dana 35 and chrystler 8.25
Is this going to be an easy and direct swap???
i bought a 1995 2 wheel drive and a 1990 4 wheel drive and i want to take the axle from the 95 and put it into my 1990
i bought a 1995 2 wheel drive and a 1990 4 wheel drive and i want to take the axle from the 95 and put it into my 1990
Junior Member
Joined: Oct 2012
Posts: 91
Likes: 0
From: Kernersville, NC
Year: 1988
Engine: 232 I6
As long as the gear ratios are the same, 100% bolt in swap. You'll need a rear drive shaft from an XJ the orgianlly had a 8.25 or you could get your current shaft shortened.
Thread Starter
Senior Member
Joined: Mar 2011
Posts: 643
Likes: 0
From: San Antonio, TX
Year: 2001
Model: Cherokee
Engine: 4.0L
so i would need a new drive shaft for both jeeps because the 2wd is going to be sold as soon as the swap is finished
Thread Starter
Senior Member
Joined: Mar 2011
Posts: 643
Likes: 0
From: San Antonio, TX
Year: 2001
Model: Cherokee
Engine: 4.0L
I want to switch this axle but I am not sure if it is going to be worth it and if everything is going to work perfectly since one is 2wd and one is 4wd
CF Veteran
Joined: Mar 2010
Posts: 47,923
Likes: 38
From: Broward County Fl.
Year: 1989 xj sport 2dr
Model: Cherokee
Engine: 12 hole bosch Injectors
Theres no benifical reason to change them the older 35s non c clip which is better thhan a c clip rear unless your planning on swapping internals from a 97 plus 8.25 which will be 29 spline .
Thread
Thread Starter
Forum
Replies
Last Post
extrashaky
Other Vehicles. Other Jeep models & cars and trucks of other makes
17
Jun 17, 2023 03:57 PM
Lightning_19k
Modified XJ Cherokee Tech
14
Oct 3, 2015 09:52 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)