d44 disc swap questions
#1
Senior Member
Thread Starter
Join Date: Feb 2009
Location: chico,ca
Posts: 553
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1989
Model: Cherokee
Engine: 4.0
d44 disc swap questions
im in the middle of a disc brake swap on my d44 rear out of an 87 xj and when i went down to napa autoparts all they have is the flat style timken set 10 bearings and it doesnt even show a cone shaped wheel bearing does any one know the part #for the right wheel bearings ive searched for quite a while and found nada
also i pulled the backing plates and calipers off of a 98 ford exploder for my swap and it doesnt seem to be the right one i read so many posts my head was starting to spin i read that i would have to bore out the center hole a little so it will fit over the oil seal and bearing and the one i got went over with plenty of room and the 4 holes to bolt it on dont match the 44 axle flange ?? if i pull the backing plates and calipers off of a zj will they have the right holes to bolt them on ?? cause i have no prob boring out the center hole
will someone point a brotha in the right direction
thanks
also i pulled the backing plates and calipers off of a 98 ford exploder for my swap and it doesnt seem to be the right one i read so many posts my head was starting to spin i read that i would have to bore out the center hole a little so it will fit over the oil seal and bearing and the one i got went over with plenty of room and the 4 holes to bolt it on dont match the 44 axle flange ?? if i pull the backing plates and calipers off of a zj will they have the right holes to bolt them on ?? cause i have no prob boring out the center hole
will someone point a brotha in the right direction
thanks
#3
Senior Member
Thread Starter
Join Date: Feb 2009
Location: chico,ca
Posts: 553
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1989
Model: Cherokee
Engine: 4.0
sweet and what about the bearings are they cone shaped or are they flat/square im not sure what p# the ones i had were i just returned them today but the ones i had pressed off were cone shaped but i just found a thread for a 44/explorer swap and they looked like the ones i had ?? so i guess i had the right ones i just wanna know before i have them pressed on
Thread
Thread Starter
Forum
Replies
Last Post
CherokeeHoonigan
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
4
09-04-2015 12:47 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)