Custom Gauges
#1
CF Veteran
Thread Starter
Custom Gauges
Has anyone ever swapped out thier stock gauges for custom ones.. or have come across a write up on such a mod? My entire cluster fails to work 97% of the time, IF they work it is usually the other gauges, speedo and tach work the least. I have taken them out a couple of times and cleaned up the connecter and reinstalled. They work for a day or two and then stop. At this point I would rather install Autometers. Any ideas, comments, suggestions?
Last edited by prerunner1982; 05-04-2008 at 07:09 PM.
#2
Senior Member
Join Date: Jan 2008
Location: Cheyenne Wyoming
Posts: 578
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0l
Here is one I came across a few days ago..might be what you are looking for..maybe not?
http://www.opiebennett.com/Gauge.htm
http://www.opiebennett.com/Gauge.htm
#3
CF Veteran
Thread Starter
SInce I am on a dial up connection (down fall of living in the country) I didnt let all the pictures load, But from reading it appears he was swapping a stock full cluster for a cluster with idiot lights. Which would be a good swap if I didnt already have a full cluster.... that just doesnt work. I am contemplating going to the pick-n-pull and trying to find one... but how long would it be before that one fails too? I would rather go with an all new gauge cluster with individual gauges not all connected to a circuit. Thanks for the link though.
#4
Seasoned Member
Join Date: Apr 2008
Posts: 269
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0 HO
Why don't you make one? I made one for my blazer out of a sheet of lexan and a bunch of AutoMeter gauges. Sort of a pain in the *** to wire and run the lines, then get the mounting to look nice, but so very cool after it was done.
#5
CF Veteran
Thread Starter
Thats the plan.. just looking for info from anyone who has done it before so I will have an idea of the problems I may run into.
The idea is to use the stock wiring if at all possible since the wires are already there. I will most likely end up custom wiring the check engine light and the other located in that area of the dash.
The idea is to use the stock wiring if at all possible since the wires are already there. I will most likely end up custom wiring the check engine light and the other located in that area of the dash.
Trending Topics
#8
CF Veteran
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post
Joshuapn
Other Vehicles. Other Jeep models & cars and trucks of other makes
1
09-25-2015 08:16 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)