clutch isses :(
Thread Starter
Newbie
Joined: Dec 2011
Posts: 2
Likes: 0
From: Flagstaff, Arizona
Year: 1988
Model: Cherokee
Engine: Straight 6
Alirghty, I really need some help....
I have a 1988 jeep cherokee chief 5 speed manie tranie and my clutch started acting up last week. It stalled while i was in neutral and wouldnt let me start it up again. But the clutch petal bounced back after i pushed it all the way to the floor. Checked the fluid level, there was none, poured some dot 3 in her, everything was fine for about 3 days. Then, it would stall in gear, and not let me take it out. Checked the fluid level, there was plenty! Now it stalls in every gear. i have noticed that it my rpms get below 1000, it dies. I have been stuck at alot of lights, and in some parking spots, so i really need some advice.
THANKS!
I have a 1988 jeep cherokee chief 5 speed manie tranie and my clutch started acting up last week. It stalled while i was in neutral and wouldnt let me start it up again. But the clutch petal bounced back after i pushed it all the way to the floor. Checked the fluid level, there was none, poured some dot 3 in her, everything was fine for about 3 days. Then, it would stall in gear, and not let me take it out. Checked the fluid level, there was plenty! Now it stalls in every gear. i have noticed that it my rpms get below 1000, it dies. I have been stuck at alot of lights, and in some parking spots, so i really need some advice.
THANKS!
Senior Member
Joined: Dec 2010
Posts: 726
Likes: 0
From: Leadville Co
Year: 2000
Model: Grand Cherokee
Engine: 4.7
Id start by bleeding the clutch. If there really was no fluid in the reservoir then you've probly introduced air into the system. Not a huge job, though. You should also see if.you can find a leak in the system.
Thread
Thread Starter
Forum
Replies
Last Post
cpnwrench
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
14
May 5, 2024 12:21 PM
NM-XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
18
Oct 23, 2018 04:21 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



