Hi,
My present clocksprings connector is broken. So i was wondering if i culd make the airbag work again by using the connector from the old faulty clockspring.

Is it possible to repair clockspring airbagwire by sodering wires? See pictures below. Thaks for helping me out!

 

I just saw a thread about this on a Ford forum. It's a different vehicle, but the same principles should apply. This might help:

https://www.ford-trucks.com/forums/1...t-working.html

If you try this and get it working, please take pictures and post back. The info will be very valuable to others.

 

I don't see any reason why it wouldn't work. I did a solder repair to the ribbon wire on my '99. It worked but not for very long. The clock spring and connector are just wires. The SRS light will only go off if the module passes all of it's tests. Do a neat solder job with heat shrink tubing and you should be good to go.