catalytic converter questions

Subscribe
Dec 30, 2011 | 08:34 AM
  #1  
hey guys quick questions I'm ordering a replacement cat converter for my 97 jeep Cherokee sport. I'm trying to figure out what size I need, I measured the front and it measured at 2.5 inches but the back is 2.25. Could anyone tell me which size I need to order?

Any advice on the install would be appreciated too! Thanks
Reply 0
Dec 30, 2011 | 08:48 AM
  #2  
You should need a 2.25 in/out. Should.

Mudfrog, a supporting vendor here, sells high flow cats for a great price. Look him up and I bet you'll get taken care of.
Reply 0
Dec 30, 2011 | 09:05 AM
  #3  
Yes, I believe that's the website I'm currently on, I haven't seen any options for a cat that's 2.5/2.25 perhaps I should send him an email?
Reply 0
Dec 30, 2011 | 09:18 AM
  #4  
Perhaps. But I don't think its 2.5/2.25.
Reply 0
Dec 30, 2011 | 10:48 AM
  #5  
Our '98 is 2.5" in/2.25" out.

catalytic converter questions-004-5-.jpg   catalytic converter questions-005-4-.jpg  

Reply 0
Dec 30, 2011 | 11:01 AM
  #6  
Well at least someone else has this as well, did you buy a specific converter?
Reply 1
Dec 30, 2011 | 11:21 AM
  #7  
Do you have a tape measure?? If so USE it. Unless of course you KNOW that your exhaust is now stock.
Reply 1
Dec 30, 2011 | 11:39 AM
  #8  
I used digital calipers, area into the muffler was at like 2.26 and the other end was 2.5
Reply 0
Dec 30, 2011 | 11:45 AM
  #9  
I bought a magnaflow direct fit......i know one end was bigger than the other....i wanna say 2.5/2.25 sound right...the 2.5 slides over the downpipe and the 2.25 slides inside the muffler
Reply 0
Subscribe
Currently Active Users (1)