Jeep wiper arms have a clip that can be released only if the arm is pulled away from the windshield. Look where the base of the wiper arm slips over the splined barrel (the stub that stick up from the cowling that rotates the arm) You will have to lift the arm away from the windshield until you can release the retainer clip and slide (wiggle) the base from the splined shaft it rests on. It sounds more complicated then it is. Just realize the base of the arm slips over the splined shaft straight...Also there is spring tension that holds the wiper towards the windshield that you have to deal with to pull the base of the arm off straight. NOTE: Look at the positioning of the arms before you remove them so you can get them back in the same location. The cowling has screws that hold it in place. Good luck!
Hope this helps...

 

it does,, thanx

 

OK so today I did this,, mod,, Ill post pics as soon as possible,, and also if you guys want,, I can do a DIY How to..

 

get some pictures up.

-Kyle

 

here you can see the entire set up,, how its inside the lower air box and then goes into the fire wall



here is a look of the tubes leaving the lower air box



here is a look of the tubes entering the fire wall



and finally a pic of were its getting the fresh air from



ok guys,, yeah,, in my opinion 2 1" tubes are to lil,, so Im planing on doing a third one,, and remember to seal the front opening of the lower air box,, if you dont,, you will still be sucking hot air..

ps. hey Kyle, if you can,, on the thread tittle,, on the end can you edit it and put,, yes it can..

 

you should make your own writeup on this in a new thread and i will sticky it.

-Kyle

 

OK,, I just arrive from Home Depot,, getting the extra tube,, I will install it and write it thanx,,

 

done, see how to on: https://www.cherokeeforum.com/f2/new-air-box-mod-887/