Hi all!
New here and looking forward to contributing and learning. I just acquired a 1988 XJ and am replacing all the brake lines. I have all the lines in except the front passenger line. I bought the replacements from inline and for the most part has been a painless swap. I can't see how the line snakes along the firewall behind the block, so I was wondering if anyone has a diagram and or insight as to how to install.

Thank you for any and all insights or help.

Peace.

 

If you flip through the pictures for this product, there's a picture without an engine in the bay. The line exits from the rear-most port on the distribution block.

https://www.overkillbydesign.com/sho...s-motor-mounts

 

I went out and did some recoin on it and found how it is piped up. It runs along the firewall lip and under the map sensor and drops down just behind the boost. I bought the pre-bent lines from Inline so in order to get this one in I will have to remove the oil filter to remove the canister to get enough room to snake it up and through. All the others went in flawlessly but hey...it's a Jeep right?

Thanks again!