Here's the issue pulled a Blower Motor Connector (to climate switch) from a 1988 Cherokee the connector is wired as:

Switch Connectors (letters marked on switch)

B-blue M-brown AC-blank


L-green H-yellow/black


Soldered the new wires to the existing wire harness all is good with the connections (same colors). Here's the problem when its wired all I have is high speed. I've replaced the switch, blower motor, and blower motor resistor.

My wires came off my 1994 Jeep Cherokee so the question is are the wiring schemes the same? Or does the 1994 have a different wiring setup?

Any assistance would be much appreciated. I've attached a pic in order for everyone to see.

I need to know what color wires go to the switch connectors. Or, am I missing something?

 

CCKen is good with wires and diagrams and the likes. Was a bomb squad tech (or thinks like one) and now prevents us from cutting the red instead of the black wires...or was is the green?

 

1988 is different than the 1994.

Here's the poop:

1994

A Tan - M1
B Dark Green - Hi
C Yellow/Brown tracer - Lo
D Light Blue - M2

1988

A Light Green - M1
B White - Hi
C Light Blue - Lo
D Tan - M2

Edit: I thought your name looked familiar. Go to post 7 in your 1st thread concerning this.

https://www.cherokeeforum.com/f2/blo...-wires-197705/

 

Thanks CC, I knew you'd be around...

 

CCKen thanks for your direction. Attached is a picture of the final wire connections works like a charm. This forum rocks alway helpful.

 

Good job.