Bleeding clutch
08-12-2015, 01:32 AM
#17
Newbie
Join Date: Aug 2015
Location: Albany, Oregon
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Year: 90
Model: Cherokee
Engine: 4.0
I am having trouble with my 90 Cherokee clutch as well.
Internal slave.
I replaced clutch assembly and slave and master as all were corroded from sitting for a couple of years.
The slave went bad after only a few days of operation, would not fully release and would blow the cap of the master.
Got clutch kit warranteed and finally installed it, along with another new master.
Now I have a low pedal and it's stiff into first and grinds into reverse, even if I pump the pedal.
I've replaced the pedal pivot bushings, power bled the system, foot bled it, hell I even let it gravity bleed a quart of fluid through it.
Still have low pedal.
What am I missing? It's probably something obvious but I'm overlooking it due to frustration...
Internal slave.
I replaced clutch assembly and slave and master as all were corroded from sitting for a couple of years.
The slave went bad after only a few days of operation, would not fully release and would blow the cap of the master.
Got clutch kit warranteed and finally installed it, along with another new master.
Now I have a low pedal and it's stiff into first and grinds into reverse, even if I pump the pedal.
I've replaced the pedal pivot bushings, power bled the system, foot bled it, hell I even let it gravity bleed a quart of fluid through it.
Still have low pedal.
What am I missing? It's probably something obvious but I'm overlooking it due to frustration...
08-02-2018, 09:52 AM
#18
Seasoned Member
So on a ‘91, with an internal slave, I don’t see a bleeder valve. Very confused on bleeding procedures.
Last edited by Rlmx; 08-02-2018 at 08:29 PM.
Thread
Thread Starter
Forum
Replies
Last Post
64dodge
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
3
09-30-2015 05:50 PM
dshirk
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
0
09-24-2015 10:17 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)